HP Designjet 5000打印机通过前面板配置网卡

1、I/O setup菜单详细点击步骤

     面板显示                                  按的按键

I/O setupà                                enter

CFG NETWORK=NOà                        enter

NO*                                      ↓

Yes                                      enter

CFG TCP/IP=YESà                          ↑ (注意一定开始要改用上箭头)

BOOTP=NOà                              ↑ (注意不要改成YES)      

IP BYTE 1=15à                            enter(IP地址设置)

15*                                      (可按↑或↓修改数值)

某某值                                   enter            

IP BYTE 2=79à                            ↑             

IP BYTE 3=53à                            ↑        

IP BYTE 4=180à                           ↑         

SM BYTE 1=255à                          ↑ (子网掩码设置)         

SM BYTE 2=255à                          ↑          

SM BYTE 3=248à                          ↑      

SM BYTE 4=0à                            ↑       

LG BYTE 1= 0à                            ↑ (Log Server设置,不一定要)       

LG BYTE 2= 0à                            ↑       

LG BYTE 3= 0à                            ↑                  

LG BYTE 4= 0à                            ↑                  

GW BYTE 1=15à                           ↑(网关设置)        

GW BYTE 2=79à                           ↑                   

GW BYTE 3=48à                           ↑                    

GW BYTE 4=1à                            ↑                   

Timeout=90                               (超时设置)

注意事项

1.       在面板上配置好IP后,不应立即在网络上查找,因为此设置要在大约5分钟后生效.

2.       设置完成后,在面板中Utilities- Test Prints-Service config打印配置文档,检查I/O Card是否处于Ready,IP地址是否配置成功.

3.       在客户端Ping此IP,是否能够Ping通.

4.       安装随机网络配置光盘,按操作进行.